#
gabilebouc@gabilebouc-HP-Laptop-15-bs0xx:~$ ifconfig
eno1: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
ether 18:60:24:b7:0d:0b txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 1000 (Boucle locale)
RX packets 112 bytes 8504 (8.5 KB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 112 bytes 8504 (8.5 KB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
wlx7c8bca1173fe: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 192.168.0.29 netmask 255.255.255.0 broadcast 192.168.0.255
inet6 fe80::16a3:9bca:af33:a163 prefixlen 64 scopeid 0x20<link>
ether 7c:8b:ca:11:73:fe txqueuelen 1000 (Ethernet)
RX packets 240 bytes 208578 (208.5 KB)
RX errors 0 dropped 165 overruns 0 frame 0
TX packets 252 bytes 27004 (27.0 KB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
Voila une fois tapé la commande "sudo dpkg-reconfigure resolvconf" et l'ifconfig faite avec l'adaptateur branché 🙂.