moko138 a écritIl manque des
dizaines de lignes. Donc montre
sudo smartctl -s on -a /dev/sda
Re,
Voici la liste pour l'autopsie de la bête :
sudo smartctl -s on -a /dev/sda
=== START OF INFORMATION SECTION ===
Model Family: Seagate Momentus 5400.7 (AF)
Device Model: ST9750423AS
Serial Number: 5WS0Y6PS
LU WWN Device Id: 5 000c50 037fb9def
Firmware Version: 0001SDM1
User Capacity: 750 156 374 016 bytes [750 GB]
Sector Sizes: 512 bytes logical, 4096 bytes physical
Rotation Rate: 5400 rpm
Device is: In smartctl database [for details use: -P show]
ATA Version is: ATA8-ACS T13/1699-D revision 4
SATA Version is: SATA 2.6, 3.0 Gb/s
Local Time is: Sun May 27 22:46:58 2018 CEST
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF ENABLE/DISABLE COMMANDS SECTION ===
SMART Enabled.
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 0) seconds.
Offline data collection
capabilities: (0x7b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 190) minutes.
Conveyance self-test routine
recommended polling time: ( 3) minutes.
SCT capabilities: (0x303f) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 118 099 006 Pre-fail Always - 167922112
3 Spin_Up_Time 0x0003 098 098 085 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 062 062 020 Old_age Always - 39049
5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 0
7 Seek_Error_Rate 0x000f 087 060 030 Pre-fail Always - 522436473
9 Power_On_Hours 0x0032 083 083 000 Old_age Always - 15650
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 082 082 020 Old_age Always - 18918
184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0
187 Reported_Uncorrect 0x0032 077 077 000 Old_age Always - 23
188 Command_Timeout 0x0032 100 099 000 Old_age Always - 87
189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0
190 Airflow_Temperature_Cel 0x0022 067 050 045 Old_age Always - 33 (Min/Max 25/33)
191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 153
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 171
193 Load_Cycle_Count 0x0032 069 069 000 Old_age Always - 63714
194 Temperature_Celsius 0x0022 033 050 000 Old_age Always - 33 (0 15 0 0 0)
195 Hardware_ECC_Recovered 0x001a 118 099 000 Old_age Always - 167922112
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 1
240 Head_Flying_Hours 0x0000 100 253 000 Old_age Offline - 15545 (77 88 0)
241 Total_LBAs_Written 0x0000 100 253 000 Old_age Offline - 2989382040
242 Total_LBAs_Read 0x0000 100 253 000 Old_age Offline - 2358515353
254 Free_Fall_Sensor 0x0032 100 100 000 Old_age Always - 0
SMART Error Log Version: 1
ATA Error Count: 23 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 23 occurred at disk power-on lifetime: 13757 hours (573 days + 5 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: WP at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
61 00 00 ff ff ff 4f 00 03:03:23.842 WRITE FPDMA QUEUED
61 00 00 ff ff ff 4f 00 03:03:23.842 WRITE FPDMA QUEUED
60 00 01 ff ff ff 4f 00 03:03:23.841 READ FPDMA QUEUED
60 00 08 98 3f 82 43 00 03:03:23.841 READ FPDMA QUEUED
60 00 00 40 f1 23 43 00 03:03:23.841 READ FPDMA QUEUED
Error 22 occurred at disk power-on lifetime: 13757 hours (573 days + 5 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 20 40 a8 20 43 00 03:02:49.458 READ FPDMA QUEUED
61 00 78 08 44 7d 43 00 03:02:49.458 WRITE FPDMA QUEUED
61 00 18 28 22 db 49 00 03:02:49.456 WRITE FPDMA QUEUED
61 00 08 78 2b 3d 43 00 03:02:49.455 WRITE FPDMA QUEUED
60 00 08 60 9c 20 43 00 03:02:49.455 READ FPDMA QUEUED
Error 21 occurred at disk power-on lifetime: 13757 hours (573 days + 5 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: WP at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
61 00 10 c0 16 7d 43 00 03:02:46.077 WRITE FPDMA QUEUED
60 00 0e 68 4a 21 43 00 03:02:46.066 READ FPDMA QUEUED
60 00 08 00 ab 81 43 00 03:02:46.066 READ FPDMA QUEUED
61 00 08 90 05 85 43 00 03:02:46.065 WRITE FPDMA QUEUED
61 00 48 68 c1 51 43 00 03:02:46.065 WRITE FPDMA QUEUED
Error 20 occurred at disk power-on lifetime: 13757 hours (573 days + 5 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: WP at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
61 00 08 90 19 80 43 00 03:02:42.923 WRITE FPDMA QUEUED
61 00 20 ff ff ff 4f 00 03:02:42.923 WRITE FPDMA QUEUED
61 00 20 80 3a 0c 4b 00 03:02:42.922 WRITE FPDMA QUEUED
60 00 20 80 19 80 43 00 03:02:42.922 READ FPDMA QUEUED
61 00 08 70 19 80 43 00 03:02:42.921 WRITE FPDMA QUEUED
Error 19 occurred at disk power-on lifetime: 13757 hours (573 days + 5 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: WP at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
61 00 14 e8 d3 00 49 00 03:02:39.916 WRITE FPDMA QUEUED
60 00 80 a0 27 20 43 00 03:02:39.916 READ FPDMA QUEUED
60 00 08 08 02 8a 43 00 03:02:39.915 READ FPDMA QUEUED
60 00 40 ff ff ff 4f 00 03:02:39.915 READ FPDMA QUEUED
60 00 38 d0 db b7 4a 00 03:02:39.915 READ FPDMA QUEUED
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed without error 00% 15646 -
# 2 Short offline Completed without error 00% 15620 -
# 3 Short offline Completed without error 00% 15620 -
# 4 Short offline Completed without error 00% 8844 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
