Bonjour,
J'essaye désespérément de monter un disque externe USB Western Digital My Passport Essential (USB 1, très ancien mais qui n'a pas beaucoup tourné - enfin si on considère que moins de 400 heures, c'est pas beaucoup), mais pas moyen.
Voilà le rapport smartctl :
sudo smartctl -s on -a /dev/sdd
[sudo] Mot de passe de moi :
smartctl 6.5 2016-01-24 r4214 [x86_64-linux-4.4.0-143-generic] (local build)
Copyright (C) 2002-16, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Device Model: WDC WD3200BMVS-11F9S0
Serial Number: WD-WXEX08T0L268
LU WWN Device Id: 5 0014ee 20236d27d
Firmware Version: 01.01A11
User Capacity: 320 072 933 376 bytes [320 GB]
Sector Size: 512 bytes logical/physical
Rotation Rate: 5400 rpm
Device is: Not in smartctl database [for details use: -P showall]
ATA Version is: ATA8-ACS (minor revision not indicated)
SATA Version is: SATA 2.5, 1.5 Gb/s
Local Time is: Fri Mar 22 14:20:30 2019 CET
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF ENABLE/DISABLE COMMANDS SECTION ===
SMART Enabled.
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x80) Offline data collection activity
was never started.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 9960) seconds.
Offline data collection
capabilities: (0x7b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 118) minutes.
Conveyance self-test routine
recommended polling time: ( 5) minutes.
SCT capabilities: (0x303f) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x002f 163 163 051 Pre-fail Always - 3973
3 Spin_Up_Time 0x0027 163 151 021 Pre-fail Always - 2833
4 Start_Stop_Count 0x0032 099 099 000 Old_age Always - 1829
5 Reallocated_Sector_Ct 0x0033 200 200 140 Pre-fail Always - 0
7 Seek_Error_Rate 0x002e 200 200 051 Old_age Always - 0
9 Power_On_Hours 0x0032 100 100 000 Old_age Always - 388
10 Spin_Retry_Count 0x0033 100 099 051 Pre-fail Always - 1
11 Calibration_Retry_Count 0x0032 100 100 000 Old_age Always - 0
12 Power_Cycle_Count 0x0032 099 099 000 Old_age Always - 1135
192 Power-Off_Retract_Count 0x0032 200 200 000 Old_age Always - 387
193 Load_Cycle_Count 0x0032 197 197 000 Old_age Always - 9200
194 Temperature_Celsius 0x0022 117 103 000 Old_age Always - 30
196 Reallocated_Event_Count 0x0032 200 200 000 Old_age Always - 0
197 Current_Pending_Sector 0x0032 180 177 000 Old_age Always - 1088
198 Offline_Uncorrectable 0x0030 100 253 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x0032 200 200 000 Old_age Always - 0
200 Multi_Zone_Error_Rate 0x0009 100 253 051 Pre-fail Offline - 0
SMART Error Log Version: 1
ATA Error Count: 2505 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 2505 occurred at disk power-on lifetime: 388 hours (16 days + 4 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 04 43 00 00 40 Error: UNC 4 sectors at LBA = 0x00000043 = 67
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 04 43 00 00 00 00 00:08:51.267 READ DMA EXT
25 00 02 41 00 00 00 00 00:08:48.299 READ DMA EXT
25 00 02 3f 00 00 00 00 00:08:45.048 READ DMA EXT
25 00 08 3f 00 00 00 00 00:08:41.803 READ DMA EXT
25 00 08 af d6 42 25 00 00:08:41.802 READ DMA EXT
Error 2504 occurred at disk power-on lifetime: 388 hours (16 days + 4 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 02 41 00 00 40 Error: UNC 2 sectors at LBA = 0x00000041 = 65
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 02 41 00 00 00 00 00:08:48.299 READ DMA EXT
25 00 02 3f 00 00 00 00 00:08:45.048 READ DMA EXT
25 00 08 3f 00 00 00 00 00:08:41.803 READ DMA EXT
25 00 08 af d6 42 25 00 00:08:41.802 READ DMA EXT
25 00 08 3f d6 42 25 00 00:08:41.802 READ DMA EXT
Error 2503 occurred at disk power-on lifetime: 388 hours (16 days + 4 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 02 3f 00 00 40 Error: UNC 2 sectors at LBA = 0x0000003f = 63
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 02 3f 00 00 00 00 00:08:45.048 READ DMA EXT
25 00 08 3f 00 00 00 00 00:08:41.803 READ DMA EXT
25 00 08 af d6 42 25 00 00:08:41.802 READ DMA EXT
25 00 08 3f d6 42 25 00 00:08:41.802 READ DMA EXT
ec 00 01 00 00 00 00 00 00:08:41.799 IDENTIFY DEVICE
Error 2502 occurred at disk power-on lifetime: 388 hours (16 days + 4 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 08 3f 00 00 40 Error: UNC 8 sectors at LBA = 0x0000003f = 63
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 08 3f 00 00 00 00 00:08:41.803 READ DMA EXT
25 00 08 af d6 42 25 00 00:08:41.802 READ DMA EXT
25 00 08 3f d6 42 25 00 00:08:41.802 READ DMA EXT
ec 00 01 00 00 00 00 00 00:08:41.799 IDENTIFY DEVICE
25 00 08 38 00 00 00 00 00:08:38.540 READ DMA EXT
Error 2501 occurred at disk power-on lifetime: 388 hours (16 days + 4 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 08 38 00 00 40 Error: UNC 8 sectors at LBA = 0x00000038 = 56
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 08 38 00 00 00 00 00:08:38.540 READ DMA EXT
25 00 08 38 00 00 00 00 00:08:35.223 READ DMA EXT
25 00 08 18 00 00 00 00 00:08:35.222 READ DMA EXT
25 00 08 00 08 00 00 00 00:08:35.222 READ DMA EXT
25 00 08 a0 de 42 25 00 00:08:35.222 READ DMA EXT
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Conveyance offline Completed: read failure 90% 385 88467775
# 2 Short offline Completed: read failure 90% 385 88467775
# 3 Extended offline Completed: read failure 90% 385 88467775
# 4 Conveyance offline Completed: read failure 90% 385 88467775
# 5 Short offline Completed: read failure 90% 385 88467775
# 6 Conveyance offline Completed: read failure 90% 382 219233792
# 7 Extended offline Completed: read failure 90% 382 219233792
# 8 Short offline Completed: read failure 90% 382 157779784
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
moi@moi-lenovo:~$
Ça m'a l'air mal barré mais sait-on jamais. Si ça peut aider, j'ai un autre disque de même taille (même modèle un peu plus ancien) qui tourne encore et qui est vide.
Merci d'avance pour votre aide.
