OK, je regarde pour l'image iso. Et il est vrai que vu mon boulot, mon ordi n'est pas toujours au bureau, et parfois seulement en veille quand je le déplace.
Pour le disque sda, voici le texte du rapport :
sudo smartctl -s on -a /dev/sda
smartctl 6.6 2016-05-31 r4324 [x86_64-linux-5.0.0-23-generic] (local build)
Copyright (C) 2002-16, Bruce Allen, Christian Franke, [url=http://www.smartmontools.org]www.smartmontools.org[/url]
=== START OF INFORMATION SECTION ===
Model Family: HGST Travelstar 5K1000
Device Model: HGST HTS541010A9E680
Serial Number: JA100A103WX3RM
LU WWN Device Id: 5 000cca 766f6f617
Firmware Version: JA0OA710
User Capacity: 1000204886016 bytes [1,00 TB]
Sector Sizes: 512 bytes logical, 4096 bytes physical
Rotation Rate: 5400 rpm
Form Factor: 2.5 inches
Device is: In smartctl database [for details use: -P show]
ATA Version is: ACS-2, ATA8-ACS T13/1699-D revision 6
SATA Version is: SATA 3.0, 6.0 Gb/s (current: 6.0 Gb/s)
Local Time is: Fri Feb 7 14:37:12 2020 CET
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF ENABLE/DISABLE COMMANDS SECTION ===
SMART Enabled.
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x00) Offline data collection activity
was never started.
Auto Offline Data Collection: Disabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 45) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 239) minutes.
SCT capabilities: (0x003d) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x002f 100 100 062 Pre-fail Always - 0
2 Throughput_Performance 0x0025 100 100 040 Pre-fail Offline - 0
3 Spin_Up_Time 0x0023 198 100 033 Pre-fail Always - 1
4 Start_Stop_Count 0x0032 086 086 000 Old_age Always - 22350
5 Reallocated_Sector_Ct 0x0033 100 100 005 Pre-fail Always - 0
7 Seek_Error_Rate 0x002f 100 100 067 Pre-fail Always - 0
8 Seek_Time_Performance 0x0025 100 100 040 Pre-fail Offline - 0
9 Power_On_Hours 0x0032 070 070 000 Old_age Always - 13315
10 Spin_Retry_Count 0x0033 100 100 060 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 093 093 000 Old_age Always - 11505
183 Runtime_Bad_Block 0x0032 100 100 000 Old_age Always - 0
184 End-to-End_Error 0x0033 100 100 097 Pre-fail Always - 0
187 Reported_Uncorrect 0x0032 100 099 000 Old_age Always - 8589934596
188 Command_Timeout 0x0032 100 100 000 Old_age Always - 51541704704
190 Airflow_Temperature_Cel 0x0022 076 054 045 Old_age Always - 24 (Min/Max 24/24)
191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 190
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 2490406
193 Load_Cycle_Count 0x0032 065 065 000 Old_age Always - 358592
196 Reallocated_Event_Count 0x0032 100 100 000 Old_age Always - 0
197 Current_Pending_Sector 0x0032 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0030 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x0036 100 100 000 Old_age Always - 0
223 Load_Retry_Count 0x002a 100 099 000 Old_age Always - 0
SMART Error Log Version: 1
ATA Error Count: 4
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 4 occurred at disk power-on lifetime: 13202 hours (550 days + 2 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 41 90 48 44 64 00 Error: WP at LBA = 0x00644448 = 6571080
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
61 00 28 00 fa fa 40 00 00:01:50.820 WRITE FPDMA QUEUED
61 00 18 00 f0 fa 40 00 00:01:50.797 WRITE FPDMA QUEUED
61 00 10 00 ea fa 40 00 00:01:50.788 WRITE FPDMA QUEUED
61 00 08 00 e0 fa 40 00 00:01:50.766 WRITE FPDMA QUEUED
61 00 00 00 da fa 40 00 00:01:50.755 WRITE FPDMA QUEUED
Error 3 occurred at disk power-on lifetime: 13191 hours (549 days + 15 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 41 08 b8 2c 16 0b Error: WP at LBA = 0x0b162cb8 = 186002616
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
61 00 08 00 a0 c0 40 00 02:44:28.817 WRITE FPDMA QUEUED
61 00 00 00 9a c0 40 00 02:44:28.809 WRITE FPDMA QUEUED
61 00 f0 00 90 c0 40 00 02:44:28.794 WRITE FPDMA QUEUED
61 90 e8 70 8f c0 40 00 02:44:28.793 WRITE FPDMA QUEUED
61 70 e0 00 8a c0 40 00 02:44:28.785 WRITE FPDMA QUEUED
Error 2 occurred at disk power-on lifetime: 13191 hours (549 days + 15 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 41 40 78 bf 99 0d Error: WP at LBA = 0x0d99bf78 = 228179832
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
61 40 88 80 7a ba 40 00 02:23:10.816 WRITE FPDMA QUEUED
61 40 80 40 75 ba 40 00 02:23:10.808 WRITE FPDMA QUEUED
61 40 78 00 70 ba 40 00 02:23:10.803 WRITE FPDMA QUEUED
61 10 a8 f0 6f ba 40 00 02:23:10.802 WRITE FPDMA QUEUED
61 40 a0 b0 6a ba 40 00 02:23:10.794 WRITE FPDMA QUEUED
Error 1 occurred at disk power-on lifetime: 6048 hours (252 days + 0 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 41 08 d8 b0 5f 00 Error: UNC
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
2f 00 01 10 00 00 28 00 00:59:04.399 READ LOG EXT
61 00 38 18 09 07 40 00 00:59:04.378 WRITE FPDMA QUEUED
61 00 30 18 08 07 40 00 00:59:04.378 WRITE FPDMA QUEUED
61 00 28 18 07 07 40 00 00:59:04.378 WRITE FPDMA QUEUED
61 00 20 18 06 07 40 00 00:59:04.378 WRITE FPDMA QUEUED
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed without error 00% 2650 -
# 2 Short offline Completed without error 00% 2618 -
# 3 Short offline Completed without error 00% 2600 -
# 4 Short offline Completed without error 00% 2577 -
# 5 Short offline Completed without error 00% 2557 -
# 6 Short offline Completed without error 00% 2537 -
# 7 Short offline Completed without error 00% 2429 -
# 8 Short offline Completed without error 00% 2367 -
# 9 Short offline Completed without error 00% 2360 -
#10 Short offline Completed without error 00% 2343 -
#11 Short offline Completed without error 00% 2327 -
#12 Short offline Completed without error 00% 2263 -
#13 Short offline Completed without error 00% 2243 -
#14 Short offline Completed without error 00% 2204 -
#15 Short offline Completed without error 00% 2127 -
#16 Short offline Completed without error 00% 2084 -
#17 Short offline Completed without error 00% 2052 -
#18 Short offline Completed without error 00% 2012 -
#19 Short offline Completed without error 00% 1997 -
#20 Short offline Completed without error 00% 1985 -
#21 Short offline Completed without error 00% 1974 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
