Bonsoir,
Merci à tous pour vos réponses !
Pour le contenu de D:, je tenterai de connecter le NAS à ma disposition et de recopier toutes mes données restantes dessus à partir d'Ubuntu Live... je n'y avais juste pas pensé (qu'on pouvait le faire avec la session live... ça paraît ridicule après coup). donc j'installerai Ubuntu en écrasant totalement Windows et les partitions existantes.
Pour la bonne santé de la partition sda2, j'ai fait le test recommandé, voici les résultats ci-dessous.
Pas tout compris :-)
Merci d'avance pour les explications !
ubuntu@ubuntu:~$ sudo smartctl -a /dev/sda2
smartctl 7.1 2019-12-30 r5022 [x86_64-linux-5.4.0-26-generic] (local build)
Copyright (C) 2002-19, Bruce Allen, Christian Franke,
www.smartmontools.org
=== START OF INFORMATION SECTION ===
Model Family: Toshiba 2.5" HDD MQ01ABD...
Device Model: TOSHIBA MQ01ABD100
Serial Number: 956VTV2AT
LU WWN Device Id: 5 000039 681f02542
Firmware Version: AX0R2J
User Capacity: 1000204886016 bytes [1,00 TB]
Sector Sizes: 512 bytes logical, 4096 bytes physical
Rotation Rate: 5400 rpm
Form Factor: 2.5 inches
Device is: In smartctl database [for details use: -P show]
ATA Version is: ATA8-ACS (minor revision not indicated)
SATA Version is: SATA 3.0, 6.0 Gb/s (current: 6.0 Gb/s)
Local Time is: Mon Jun 22 19:27:59 2020 UTC
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x00) Offline data collection activity
was never started.
Auto Offline Data Collection: Disabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 120) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 237) minutes.
SCT capabilities: (0x003d) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000b 100 100 050 Pre-fail Always - 0
2 Throughput_Performance 0x0005 100 100 050 Pre-fail Offline - 0
3 Spin_Up_Time 0x0027 100 100 001 Pre-fail Always - 1744
4 Start_Stop_Count 0x0032 100 100 000 Old_age Always - 7212
5 Reallocated_Sector_Ct 0x0033 100 100 050 Pre-fail Always - 8
7 Seek_Error_Rate 0x000b 100 100 050 Pre-fail Always - 0
8 Seek_Time_Performance 0x0005 100 100 050 Pre-fail Offline - 0
9 Power_On_Hours 0x0032 071 071 000 Old_age Always - 11821
10 Spin_Retry_Count 0x0033 244 100 030 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 7198
191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 2375
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 41
193 Load_Cycle_Count 0x0032 095 095 000 Old_age Always - 52832
194 Temperature_Celsius 0x0022 100 100 000 Old_age Always - 33 (Min/Max 11/46)
196 Reallocated_Event_Count 0x0032 100 100 000 Old_age Always - 1
197 Current_Pending_Sector 0x0032 100 100 000 Old_age Always - 10608
198 Offline_Uncorrectable 0x0030 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x0032 200 200 000 Old_age Always - 0
220 Disk_Shift 0x0002 100 100 000 Old_age Always - 0
222 Loaded_Hours 0x0032 075 075 000 Old_age Always - 10297
223 Load_Retry_Count 0x0032 100 100 000 Old_age Always - 0
224 Load_Friction 0x0022 100 100 000 Old_age Always - 0
226 Load-in_Time 0x0026 100 100 000 Old_age Always - 265
240 Head_Flying_Hours 0x0001 100 100 001 Pre-fail Offline - 0
SMART Error Log Version: 1
ATA Error Count: 65489 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 65489 occurred at disk power-on lifetime: 11807 hours (491 days + 23 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 41 38 60 4f 68 40 Error: UNC at LBA = 0x00684f60 = 6836064
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 40 78 4f 68 40 00 00:05:09.555 READ FPDMA QUEUED
60 00 38 78 4e 68 40 00 00:05:05.831 READ FPDMA QUEUED
60 00 08 78 4d 68 40 00 00:05:05.830 READ FPDMA QUEUED
60 00 00 78 4c 68 40 00 00:05:05.829 READ FPDMA QUEUED
60 00 f8 78 4b 68 40 00 00:05:05.829 READ FPDMA QUEUED
Error 65488 occurred at disk power-on lifetime: 11807 hours (491 days + 23 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 41 70 60 4f 68 40 Error: UNC at LBA = 0x00684f60 = 6836064
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 78 78 4f 68 40 00 00:00:41.919 READ FPDMA QUEUED
60 00 70 78 4e 68 40 00 00:00:38.194 READ FPDMA QUEUED
60 00 68 78 4d 68 40 00 00:00:38.149 READ FPDMA QUEUED
60 00 60 78 4c 68 40 00 00:00:38.148 READ FPDMA QUEUED
60 00 58 78 4b 68 40 00 00:00:38.147 READ FPDMA QUEUED
Error 65487 occurred at disk power-on lifetime: 11807 hours (491 days + 23 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 41 88 60 4f 68 40 Error: UNC at LBA = 0x00684f60 = 6836064
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 90 78 4f 68 40 00 01:04:14.979 READ FPDMA QUEUED
60 00 88 78 4e 68 40 00 01:04:11.243 READ FPDMA QUEUED
60 00 80 78 4d 68 40 00 01:04:11.242 READ FPDMA QUEUED
60 00 78 78 4c 68 40 00 01:04:11.242 READ FPDMA QUEUED
60 08 e8 00 80 93 40 00 01:04:11.224 READ FPDMA QUEUED
Error 65486 occurred at disk power-on lifetime: 11807 hours (491 days + 23 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 41 10 60 4f 68 40 Error: UNC at LBA = 0x00684f60 = 6836064
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 18 78 4f 68 40 00 01:04:05.078 READ FPDMA QUEUED
60 00 10 78 4e 68 40 00 01:04:01.354 READ FPDMA QUEUED
60 00 08 78 4d 68 40 00 01:04:01.353 READ FPDMA QUEUED
60 00 00 78 4c 68 40 00 01:04:01.352 READ FPDMA QUEUED
60 00 f0 78 4b 68 40 00 01:04:01.351 READ FPDMA QUEUED
Error 65485 occurred at disk power-on lifetime: 11807 hours (491 days + 23 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 41 98 60 4f 68 40 Error: UNC at LBA = 0x00684f60 = 6836064
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 a0 78 4f 68 40 00 01:02:38.874 READ FPDMA QUEUED
60 00 98 78 4e 68 40 00 01:02:35.149 READ FPDMA QUEUED
60 00 90 78 4d 68 40 00 01:02:35.148 READ FPDMA QUEUED
60 00 88 78 4c 68 40 00 01:02:35.148 READ FPDMA QUEUED
60 00 80 78 4b 68 40 00 01:02:35.147 READ FPDMA QUEUED
SMART Self-test log structure revision number 1
No self-tests have been logged. [To run self-tests, use: smartctl -t]
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
