ubuntu-budgie@ubuntu-budgie:~$ sudo smartctl -s on -a /dev/sda
smartctl 7.1 2019-12-30 r5022 [x86_64-linux-5.4.0-26-generic] (local build)
Copyright (C) 2002-19, Bruce Allen, Christian Franke,
www.smartmontools.org
=== START OF INFORMATION SECTION ===
Model Family: Toshiba 3.5" DT01ACA... Desktop HDD
Device Model: TOSHIBA DT01ACA100
Serial Number: 18AWL5TMS
LU WWN Device Id: 5 000039 fd5cc8a4a
Firmware Version: MS2OA8K0
User Capacity: 1,000,204,886,016 bytes [1.00 TB]
Sector Sizes: 512 bytes logical, 4096 bytes physical
Rotation Rate: 7200 rpm
Form Factor: 3.5 inches
Device is: In smartctl database [for details use: -P show]
ATA Version is: ATA8-ACS T13/1699-D revision 4
SATA Version is: SATA 3.0, 6.0 Gb/s (current: 3.0 Gb/s)
Local Time is: Thu Jul 16 15:04:01 2020 UTC
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF ENABLE/DISABLE COMMANDS SECTION ===
SMART Enabled.
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: FAILED!
Drive failure expected in less than 24 hours. SAVE ALL DATA.
See vendor-specific Attribute list for failed Attributes.
General SMART Values:
Offline data collection status: (0x84) Offline data collection activity
was suspended by an interrupting command from host.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 7458) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 125) minutes.
SCT capabilities: (0x003d) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000b 057 057 016 Pre-fail Always - 658575820
2 Throughput_Performance 0x0005 051 051 054 Pre-fail Offline FAILING_NOW 3019
3 Spin_Up_Time 0x0007 199 199 024 Pre-fail Always - 100 (Average 131)
4 Start_Stop_Count 0x0012 100 100 000 Old_age Always - 553
5 Reallocated_Sector_Ct 0x0033 001 001 005 Pre-fail Always FAILING_NOW 1997
7 Seek_Error_Rate 0x000b 100 100 067 Pre-fail Always - 0
8 Seek_Time_Performance 0x0005 113 113 020 Pre-fail Offline - 35
9 Power_On_Hours 0x0012 100 100 000 Old_age Always - 1071
10 Spin_Retry_Count 0x0013 100 100 060 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 553
192 Power-Off_Retract_Count 0x0032 069 069 000 Old_age Always - 38005
193 Load_Cycle_Count 0x0012 069 069 000 Old_age Always - 38005
194 Temperature_Celsius 0x0002 150 150 000 Old_age Always - 40 (Min/Max 11/47)
196 Reallocated_Event_Count 0x0032 001 001 000 Old_age Always - 3001
197 Current_Pending_Sector 0x0022 100 100 000 Old_age Always - 40
198 Offline_Uncorrectable 0x0008 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x000a 200 200 000 Old_age Always - 0
SMART Error Log Version: 1
ATA Error Count: 35605 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 35605 occurred at disk power-on lifetime: 1071 hours (44 days + 15 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 08 70 68 70 04 Error: UNC 8 sectors at LBA = 0x04706870 = 74475632
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 08 70 68 70 e0 08 02:11:05.579 READ DMA EXT
25 00 08 68 68 70 e0 08 02:11:02.375 READ DMA EXT
25 00 08 60 68 70 e0 08 02:10:59.138 READ DMA EXT
25 00 08 58 68 70 e0 08 02:10:55.868 READ DMA EXT
25 00 08 50 68 70 e0 08 02:10:52.532 READ DMA EXT
Error 35604 occurred at disk power-on lifetime: 1071 hours (44 days + 15 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 08 f8 69 70 04 Error: UNC 8 sectors at LBA = 0x047069f8 = 74476024
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 08 f8 69 70 e0 08 02:09:29.051 READ DMA EXT
25 00 08 d0 69 70 e0 08 02:09:25.881 READ DMA EXT
25 00 08 e0 69 70 e0 08 02:09:22.751 READ DMA EXT
25 00 08 20 6a 70 e0 08 02:09:19.573 READ DMA EXT
25 00 08 d0 6a 70 e0 08 02:09:16.394 READ DMA EXT
Error 35603 occurred at disk power-on lifetime: 1071 hours (44 days + 15 hours)
When the command that caused the error occurred, the device was doing SMART Offline or Self-test.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 08 00 6d 70 04 Error: UNC 8 sectors at LBA = 0x04706d00 = 74476800
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 08 00 6d 70 e0 08 02:08:46.433 READ DMA EXT
ec 00 01 00 00 00 00 08 02:08:46.424 IDENTIFY DEVICE
c8 00 08 00 02 00 e0 08 02:07:31.939 READ DMA
25 00 08 a8 6d 70 e0 08 02:07:28.708 READ DMA EXT
c8 00 08 80 00 00 e0 08 02:07:28.708 READ DMA
Error 35602 occurred at disk power-on lifetime: 1071 hours (44 days + 15 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 08 70 68 70 04 Error: UNC 8 sectors at LBA = 0x04706870 = 74475632
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 08 70 68 70 e0 08 02:06:20.070 READ DMA EXT
25 00 08 68 68 70 e0 08 02:06:16.875 READ DMA EXT
25 00 08 60 68 70 e0 08 02:06:13.646 READ DMA EXT
25 00 08 58 68 70 e0 08 02:06:10.451 READ DMA EXT
25 00 08 50 68 70 e0 08 02:06:07.255 READ DMA EXT
Error 35601 occurred at disk power-on lifetime: 1071 hours (44 days + 15 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 08 00 6d 70 04 Error: UNC 8 sectors at LBA = 0x04706d00 = 74476800
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 08 00 6d 70 e0 08 02:04:11.592 READ DMA EXT
ef 10 02 00 00 00 a0 08 02:04:11.439 SET FEATURES [Enable SATA feature]
27 00 00 00 00 00 e0 08 02:04:11.439 READ NATIVE MAX ADDRESS EXT [OBS-ACS-3]
ec 00 00 00 00 00 a0 08 02:04:11.437 IDENTIFY DEVICE
ef 03 46 00 00 00 a0 08 02:04:11.436 SET FEATURES [Set transfer mode]
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Selective offline Completed: read failure 60% 927 502896
# 2 Short offline Completed: read failure 50% 927 502896
# 3 Short offline Completed: read failure 50% 926 502896
# 4 Short offline Completed: read failure 50% 926 502896
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 1953525167 Completed [00% left] (1387664-1453199)
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
ubuntu-budgie@ubuntu-budgie:~$
