Bonjour tout le monde.
Vu qu'on est en reconfinement , j'en profite pour passer mon ordi de 16.04 à 20.04 ! 😉
Mais n'ayant pas pu installer de paquet depuis une live session usb pour bien tester mon ordi, je me suis résolu à faire une installation test sur un vieux disque dur 200Go vide.
Problème , à la fin de la procédure ça m'a signalé un plantage avec une invitation à transmettre un rapport. Ce que j'ai fais...
Et juste après j'ai eu une fenêtre en anglais qui semblait me dire que mon disque dur est à vérifier , et aussi de vérifier sa connectique (j'ai pris des photos car je pouvais pas faire de capture)
Là j'écris de l'ordi en question sans avoir redémarré. en session live finalement je crois vu que tout est en anglais sauf le clavier et que j'ai encore le raccourci "install ubuntu" sur le bureau, et que j'ai "ubuntu@ubuntu" comme user dans mon terminal !
Bon bref avant de vider un autre HDD plus gros et plus récent pour tester, je voulais avoir confirmation que c'est bien le HDD qui est trop vieux alors j'ai regardé mes données SMART :
ubuntu@ubuntu:~$ sudo smartctl -a /dev/sda
smartctl 7.1 2019-12-30 r5022 [x86_64-linux-5.4.0-26-generic] (local build)
Copyright (C) 2002-19, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Model Family: Western Digital Caviar SE Serial ATA
Device Model: WDC WD2000JD-00HBB0
Serial Number: WD-WMAL72790376
Firmware Version: 08.02D08
User Capacity: 200,049,647,616 bytes [200 GB]
Sector Size: 512 bytes logical/physical
Device is: In smartctl database [for details use: -P show]
ATA Version is: ATA/ATAPI-6 (minor revision not indicated)
Local Time is: Thu Nov 5 17:37:11 2020 CET
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x84) Offline data collection activity
was suspended by an interrupting command from host.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 5800) seconds.
Offline data collection
capabilities: (0x7b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
No General Purpose Logging support.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 75) minutes.
Conveyance self-test routine
recommended polling time: ( 5) minutes.
SCT capabilities: (0x003f) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000b 200 199 051 Pre-fail Always - 1
3 Spin_Up_Time 0x0007 130 114 021 Pre-fail Always - 6016
4 Start_Stop_Count 0x0032 098 098 040 Old_age Always - 2899
5 Reallocated_Sector_Ct 0x0033 200 200 140 Pre-fail Always - 0
7 Seek_Error_Rate 0x000b 200 200 051 Pre-fail Always - 0
9 Power_On_Hours 0x0032 086 086 000 Old_age Always - 10631
10 Spin_Retry_Count 0x0013 100 100 051 Pre-fail Always - 0
11 Calibration_Retry_Count 0x0013 100 100 051 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 874
194 Temperature_Celsius 0x0022 109 093 000 Old_age Always - 41
196 Reallocated_Event_Count 0x0032 200 200 000 Old_age Always - 0
197 Current_Pending_Sector 0x0012 200 200 000 Old_age Always - 1
198 Offline_Uncorrectable 0x0012 200 200 000 Old_age Always - 0
199 UDMA_CRC_Error_Count 0x000a 200 253 000 Old_age Always - 14
200 Multi_Zone_Error_Rate 0x0009 200 200 051 Pre-fail Offline - 0
SMART Error Log Version: 1
ATA Error Count: 2
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 2 occurred at disk power-on lifetime: 10630 hours (442 days + 22 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 08 38 08 50 e0 Error: UNC 8 sectors at LBA = 0x00500838 = 5244984
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 08 38 08 50 00 00 00:29:57.800 READ DMA
ea 00 00 00 00 00 00 00 00:29:57.800 FLUSH CACHE EXT
ca 00 08 e8 8d ac 0b 00 00:29:57.800 WRITE DMA
ea 00 00 00 00 00 00 00 00:29:57.800 FLUSH CACHE EXT
ca 00 60 88 8d ac 0b 00 00:29:57.800 WRITE DMA
Error 1 occurred at disk power-on lifetime: 10601 hours (441 days + 17 hours)
When the command that caused the error occurred, the device was doing SMART Offline or Self-test.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 20 40 81 42 40 Error: UNC 32 sectors at LBA = 0x00428140 = 4358464
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 20 6f 80 42 00 00 04:26:32.450 READ DMA EXT
25 00 20 17 7e 42 00 00 04:26:32.450 READ DMA EXT
25 00 20 f7 7b 42 00 00 04:26:32.450 READ DMA EXT
25 00 20 c7 79 42 00 00 04:26:32.450 READ DMA EXT
25 00 20 af 77 42 00 00 04:26:32.450 READ DMA EXT
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed without error 00% 10626 -
# 2 Short offline Completed without error 00% 10626 -
# 3 Short offline Completed: read failure 10% 10615 4358464
# 4 Short offline Completed: read failure 10% 10615 4358464
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
Donc pour vous c'est vraiment un HDD bon à jetter ? j'ai lu que la durée de vie moyenne serait plus proche de 60 000H que des 10 631 du mien... :rolleyes:
Merci! :cool:
