Par contre comment désactiver le protocole adr inet6 ?
ifconfig del adr/lg_prefix
C'est en rapport avec ipv6 ?
dans "network manager" l'onglet paramètres IPv6, la méthode est positionnée à "ignorer".
un extrait de "dmesg"
[ 48.670131] wlan0: deauthenticating from 00:17:33:5b:09:d1 by local choice (reason=3)
[ 48.677025] wlan0: authenticate with 00:17:33:5b:09:d1 (try 1)
[ 48.679951] wlan0: authenticated
[ 48.680918] wlan0: associate with 00:17:33:5b:09:d1 (try 1)
[ 48.685432] wlan0: RX AssocResp from 00:17:33:5b:09:d1 (capab=0x411 status=0 aid=1)
[ 48.685436] wlan0: associated
[ 48.691071] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[ 49.719831] padlock: VIA PadLock not detected.
[ 59.676067] wlan0: no IPv6 routers present
[ 118.448133] usb 5-1: USB disconnect, address 2
[ 118.448747] btusb_intr_complete: hci0 urb f68fae80 failed to resubmit (19)
[ 118.448770] btusb_bulk_complete: hci0 urb f68fa400 failed to resubmit (19)
[ 118.449737] btusb_bulk_complete: hci0 urb f68fa600 failed to resubmit (19)
[ 118.449948] btusb_send_frame: hci0 urb ee9e3980 submission failed
[ 118.522274] iwl3945 0000:05:00.0: Card state received: HW:Kill SW:On
[ 118.522356] iwl3945 0000:05:00.0: Not sending command - RF KILL
[ 118.522363] iwl3945 0000:05:00.0: Error sending REPLY_QOS_PARAM: enqueue_hcmd failed: -5
[ 118.522376] iwl3945 0000:05:00.0: Not sending command - RF KILL
[ 118.522382] iwl3945 0000:05:00.0: Error sending REPLY_RXON: enqueue_hcmd failed: -5
[ 118.522388] iwl3945 0000:05:00.0: Error setting new configuration (-5).
[ 118.522394] iwl3945 0000:05:00.0: Not sending command - RF KILL
[ 118.522399] iwl3945 0000:05:00.0: Error sending REPLY_RXON_ASSOC: enqueue_hcmd failed: -5
[ 118.532399] iwl3945 0000:05:00.0: Not sending command - RF KILL
[ 118.532409] iwl3945 0000:05:00.0: Error sending REPLY_REMOVE_STA: enqueue_hcmd failed: -5
[ 118.532418] iwl3945 0000:05:00.0: Error removing station 00:17:33:5b:09:d1
[ 118.548114] wlan0: deauthenticating from 00:17:33:5b:09:d1 by local choice (reason=3)
[ 118.548164] iwl3945 0000:05:00.0: Not sending command - RF KILL
[ 118.548171] iwl3945 0000:05:00.0: Error sending REPLY_RXON: enqueue_hcmd failed: -5
[ 118.548178] iwl3945 0000:05:00.0: Error setting new configuration (-5).
[ 118.564118] iwl3945 0000:05:00.0: Not sending command - RF KILL
[ 118.564127] iwl3945 0000:05:00.0: Error sending REPLY_RXON: enqueue_hcmd failed: -5
[ 118.564136] iwl3945 0000:05:00.0: Error setting new configuration (-5).
[ 118.600058] iwl3945 0000:05:00.0: MAC is in deep sleep!. CSR_GP_CNTRL = 0x040003DD
[ 118.628749] cfg80211: All devices are disconnected, going to restore regulatory settings
[ 118.628760] cfg80211: Restoring regulatory settings
[ 118.628767] cfg80211: Calling CRDA to update world regulatory domain
[ 118.632849] cfg80211: World regulatory domain updated:
[ 118.632855] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[ 118.632863] (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 118.632869] (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[ 118.632875] (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[ 118.632882] (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 118.632888] (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 125.263881] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 135.606433] wlan0: deauthenticating from 00:17:33:5b:09:d1 by local choice (reason=3)
[ 135.606635] wlan0: authenticate with 00:17:33:5b:09:d1 (try 1)
[ 135.609049] wlan0: authenticated
[ 135.612392] wlan0: associate with 00:17:33:5b:09:d1 (try 1)
[ 135.615608] wlan0: RX AssocResp from 00:17:33:5b:09:d1 (capab=0x411 status=0 aid=1)
[ 135.615616] wlan0: associated
[ 135.623579] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[ 145.888031] wlan0: no IPv6 routers present
[ 5711.856114] No probe response from AP 00:17:33:5b:09:d1 after 500ms, disconnecting.
[ 5711.896102] cfg80211: All devices are disconnected, going to restore regulatory settings
[ 5711.896112] cfg80211: Restoring regulatory settings
[ 5711.896119] cfg80211: Calling CRDA to update world regulatory domain
[ 5711.901314] cfg80211: World regulatory domain updated:
[ 5711.901321] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[ 5711.901328] (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 5711.901335] (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[ 5711.901341] (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[ 5711.901347] (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 5711.901354] (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 5714.801289] wlan0: authenticate with 00:17:33:5b:09:d1 (try 1)
[ 5714.808080] wlan0: authenticated
[ 5714.808163] wlan0: associate with 00:17:33:5b:09:d1 (try 1)
[ 5714.810721] wlan0: RX AssocResp from 00:17:33:5b:09:d1 (capab=0x411 status=0 aid=1)
[ 5714.810728] wlan0: associated
[ 6697.020374] lo: Disabled Privacy Extensions
[ 6999.824234] wlan0: deauthenticating from 00:17:33:5b:09:d1 by local choice (reason=3)
[ 6999.837470] cfg80211: All devices are disconnected, going to restore regulatory settings
[ 6999.837480] cfg80211: Restoring regulatory settings
[ 6999.837486] cfg80211: Calling CRDA to update world regulatory domain
[ 6999.842682] cfg80211: World regulatory domain updated:
[ 6999.842690] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[ 6999.842697] (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 6999.842704] (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[ 6999.842710] (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[ 6999.842716] (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 6999.842722] (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
...
[ 7010.848839] wlan0: deauthenticating from 00:17:33:5b:09:d1 by local choice (reason=3)
[ 7010.883850] wlan0: authenticate with 00:17:33:5b:09:d1 (try 1)
[ 7010.885677] wlan0: authenticated
[ 7010.885728] wlan0: associate with 00:17:33:5b:09:d1 (try 1)
[ 7010.888439] wlan0: RX AssocResp from 00:17:33:5b:09:d1 (capab=0x411 status=0 aid=1)
[ 7010.888446] wlan0: associated
[ 7010.890514] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[ 7021.296041] wlan0: no IPv6 routers present
